Interface Converters

 Eight 16-bit analog input channels of 0 – 10V input range. Internal hardware and software calibration capabilities. Programmable PGA of eight gains setting from 1x to 128x. Burn out current source for detecting open circuit and short circuit of the sensor 

 The model PRO-AMOD-01 IS 4 to 20 / 0 to 10 v input to Modbus converter. 

The model PRO-CL-01 is high speed RS232 to current loop converter. This current loop Converter is suitable for distances up to 1.2 km. Over two twisted pair. The model supports active as well as passive port. (dip switch selectable)

 The model PRO-E-01 is high speed RS 232 to RS 485 converter supporting auto baud rate 

PRO-ET-01(Ethernet to rs232 / rs485 converter) is used to put devices on network so that the remote devices can be made easily accessible through network communication

PRO-ET-02 (Ethernet to rs232 / rs485 converter) is used to put devices on network so that the remote devices can be made easily accessible through network communication.

It has 2 ports. Port1 & port2

PRO-ET-06  (Ethernet to rs232 / rs485 converter) is used to put devices on network so that the remote devices can be made easily accessible through network communication.

It has 6 ports

PRO-I-01 is used for providing isolation to serial [rs232] interface. The optical isolation protects one segment of your network from problems that arises on the other.

 The model PRO-R-01 is high speed RS 422/485 isolator (repeater). It boosts RS 422/485 signals up to 1.2 km. over one or two twisted pair

The model PRO- U-01 is USB bus power, high speed USB  to RS232- converter. It supports auto baud rate 

The model PRO-U-02 is USB bus power, high speed, USB to rs485- (2 wire /4 wire) converter. It supports auto baud rate 

The model PRO-U-03 is USB bus power, high speed, USB to RS232 / RS485- (2 wire /4 wire) Converter. It supports auto baud rate.